Foam Hopper •

Fat Albert

A high-floating foam terrestrial created by Brent Taylor. It is built entirely from foam, thread and rubber legs: a brown foam back over three tan foam segments, a short bright McFlyFoam indicator, knotted rubber legs at the rear and plain legs at the front. It floats well enough to carry a dropper and suggests grasshoppers, beetles and cicadas in summer and early fall. It is popular on western meadow and canyon rivers and works in both fast and slow water.

Tie this Fly
Fat Albert

How to Tie the Fat Albert

PartMaterial
HookTMC 5262, 2302 or 5263 #4–10
ThreadUTC 140 denier rusty brown
Body1/8" foam strips, hook-gap wide: one brown (top), two tan (underside and front segment)
Indicatorbrightly colored McFlyFoam, trimmed to a short puff
Legsround rubber legs: one knotted strand per side at the rear, one plain strand per side at the front; optionally barred with black marker

Step-by-Step Instructions

  1. 1

    Thread Base

    Start the thread behind the eye and make a thread base at least partway down the bend.

  2. 2

    Tie In Foam Strips

    Tie a hook-gap-wide brown foam strip in near the eye and wrap back over it to the bend. Tie a tan strip in at the front on top of the brown and wrap back over it to the bend, binding the foam tightly. Cover all the foam on the shank with a smooth layer of thread.

  3. 3

    Tan Segments

    Pull the tan foam forward and bind it down with two tight wraps about even with the hook barb. Lift it, move the thread forward an equal distance and bind down again. Repeat once more to make three segments that end just past the middle of the shank.

  4. 4

    Brown Back

    Pull the brown foam strip over the top of the tan segments and bind it down in the last tan segment.

  5. 5

    Indicator and Front Strip

    Bind a clump of brightly colored McFlyFoam at its center in the same segment. Tie a second hook-gap-wide tan foam strip down in the same segment, then trim the McFlyFoam to a short puff.

  6. 6

    Rear Legs

    Tie a knotted rubber leg strand on each side of the body at the last segment.

  7. 7

    Front Segment

    Advance the thread toward the eye, bind all three foam strips down behind the eye, and clip the foam at the eye.

  8. 8

    Front Legs and Finish

    Tie a plain rubber leg strand on each side at the front joint, whip finish, round the corners of the head with scissors and trim the front legs to match the rear legs. Stripe the legs with black marker if you like.

How to Fish the Fat Albert

High-floating foam hopper effective during summer and early fall when terrestrials are active. The exceptional buoyancy makes it ideal for fast-moving water, riffles, and pocket water where other patterns might sink. Also effective in stillwater situations where high floatation is needed. Dead drift along banks, overhanging vegetation, and structure where terrestrials accumulate. The hi-vis indicator makes it excellent for tracking in challenging conditions. Works well as standalone dry fly or as indicator in hopper-dropper rigs. Best fished with medium tippet (3X-5X) for hopper size. Popular in Montana and Colorado where it's considered a confidence pattern for midsummer hopper fishing. Size down (#10-12) for selective fish or smaller waters. Effective in multiple colors: black (visibility), purple (striking), tan (general), yellow (bright conditions).